ABB ACS 301-2P7-1 - Page 59

ACS 300 User’s Manual 45
Chapter 6 - Control and Parameter Logic
Figure 6-3 Example of Control Panel operation. Let us suppose
that you want to set Page 2 parameter CON f1 to 15 Hz. The
following example explains the procedure required starting from
the Page 1 parameter SPEED.
Note! To accelerate the rate of change of parameter value, press
and hold the or key.
To change to Page 2, press
Select the required Parameter by pressing
.
Change to Setting mode.
Blinking indicates that the parameter value can
Set the parameter value.
Save the selected value to permanent memory.
Blinking stops, indicating that the parameter value is
stored in memory.
now be changed.
)
(
)
(