22 ACS 300 User’s Manual
Chapter 4 - Control Connections
Figure 4-1 Control Card
Notes for Figure 4-1
X1 = Terminal block for control connections.
X2 = Plug connection to control panel.
X5 = Jumper for selecting analog input signal. See detail A.
I
= current 0(4) to 20 mA and
U
= voltage 0(2) to 10 V.
S1 = I/O option switch for selecting digital input functions
DI1 to DI5 and parameter lock.
R191 = 0 ohm resistor (jumper wire). Cut to disconnect logic
common from chassis ground.
S1
X2
X1
R191
X5
A:
U
I
To Next Page
Loading...
