ACS 300 User’s Manual 43
Chapter 6 - Control and Parameter Logic
Example Let us suppose that you want to set Page 2 parameter
CON f1 to 15 Hz. The following example explains the proce-
dure required starting from the Page 1 parameter SPEED.
Figure 6-3 Example of Control Panel operation.
Note! To accelerate the rate of change of parameter value,
press and hold the or key.
To change to Page 2, press
Select the required Parameter by pressing
Change to Setting mode.
Blinking indicates that the parameter
Set the parameter value.
Save the selected value to permanent
Blinking stops, indicating that the
)
(
)
(
value can now be changed.
parameter value is stored in memory.
memory.
Scroll to the top of Page 1.
To Next Page
Loading...
