50 ACS 300 User’s Manual
Chapter 7 - Drive Parameters
225 1. RELAY 1-11 1 67 Relay 1 function selection
226 2. RELAY 1-11 7 67 Relay 2 function selection
227 F SUPERV 0.0 to 500 Hz 70 Relay function output freq. limit
1) Depends on the selected nominal motor frequency (Page 1 parameter NOM FREQ)
Code Parameter Range Default Customer Page Description
Page 3 (*P4) 71 Press
to change to page 4
701 DC HOLD 0/ 1/ 2 0 71 None/ Normal/ Strong DC hold
702 PARAM SET 1/ 2 1 72 Enables/disables extended I/O
configuration/ Parameter set 2
703 PI-GAIN (0) 0 - 800 % 0 72 PI-Controller Gain selection
704 PI-ITIME 0.0 - 320.0 s 0 73 PI-Controller I-time selection
705 PI-SCMIN -999.9 - 999.9% 0 74 Minimum scaling factor of Actual
value
706 PI-SCMAX -999.9 - 999.9% 100 74 Maximum scaling factor of Actual
value
707 PI-REF(L) 0.0 - 100.0 0 76 PI-Controller Reference value
717 VERSION Display only 76 Displays program version
718 P. LOCK Open/ Locked Open 76
Code Parameter Range Default
Cus
tomer
Page Description
To Next Page
Loading...
