ACS 300 User’s Manual 59
Chapter 7 - Drive Parameters
Figure 7-2 Joystick control.
CUSTOM
Use this setting if you want to set and use customised minimum
and maximum limits for the reference input. The customised
limits are valid when CUSTOM is selected.
To set the limits, refer to selections SET MIN and SET MAX
below.
SET MIN (displayed in % of the full input signal range)
SET MAX (displayed in % of the full input signal range)
Sets the minimum/maximum limit for the reference input signal.
To set the minimum reference signal level, scroll to SET MIN and
MAX FREQ
MID
+2%-2%
MIN FREQ
- MIN FREQ
- MAX FREQ
2V / 4mA
0V / 0mA
MIN FREQ
- MIN FREQ
10V / 20mA
Hysteresis 4% of
Full Scale
To Next Page
Loading...
