10 ACS510 User’s Manual
Installation
• Tape measure
•Drill
• Mounting hardware: screws or nuts and bolts, four each. The type of hardware
depends on the mounting surface and the frame size:
Suitable Environment and Enclosure
Confirm that the site meets the environmental requirements. To prevent damage
prior to installation, store and transport the drive according to the environmental
requirements specified for storage and transportation. See "Ambient Conditions"
on
page
235.
Confirm that the enclosure is appropriate, based on the site contamination level:
• IP21 enclosure. The site must be free of airborne dust, corrosive gases or liquids,
and conductive contaminants such as condensation, carbon dust, and metallic
particles.
• IP54 enclosure. This enclosure provides protection from airborne dust and light
sprays or splashing water from all directions.
Suitable Mounting Location
Confirm that the mounting location meets the following constraints:
• The drive must be mounted vertically on a smooth, solid surface, and in a suitable
environment as defined above.
• The minimum space requirements for the drive are the outside dimensions (see
"Outside Dimensions" on page
233), plus air flow space around the unit (see
"Cooling"
on page 230).
• The distance between the motor and the drive is limited by the maximum motor
cable length. See either "Motor Connection Specifications"
on page 220, or "Motor
Cable Requirements for CE Compliance" on page 223.
• The mounting site must support the drive’s modest weight. See "Weight" on page
234.
Frame Size Mounting Hardware
R1…R4 M5 #10
R5 M6
1/4 in
R6 M8 5/16 in
Supplied from China by: Guangzhou Tofee Electro Mechanical Equipment Co., Ltd
Email: info@tofee.com.cn
To Next Page
Loading...
