ABB ACS530-04 - Fuses (IEC); Dimensions, Weights and Free Space Requirements

Technical data 117
Fuses (IEC)
aR fuses for protection against short-circuit in the input power cable or drive are listed
below.
Note 1: See also Implementing thermal overload and short-circuit protection on page 61.
Note 2: In multicable installations, install only one fuse per phase (not one fuse per conductor).
Note 3: Fuses with higher current rating than the recommended ones must not be used. Fuses with lower
current rating can be used.
Note 4: Fuses from other manufacturers can be used if they meet the ratings and the melting curve of the fuse
does not exceed the melting curve of the fuse mentioned in the table.
Dimensions, weights and free space requirements
For requirements of free space around the drive module, see page 49.
Ultrarapid (aR) fuses
Drive type
ACS530-04-
Input
current
(A)
Fuse
AA
2
s V Manufacturer Type DIN 43620 Size
U
N
= 380…415 V (380, 400, 415 V)
505A-4 505 800 490000 690 Bussmann 170M6812D DIN3
585A-4 585 1000 985000 690 Bussmann 170M6814D DIN3
650A-4 650 1000 985000 690 Bussmann 170M6814D DIN3
725A-4 725 1250 2150000 690 Bussmann 170M8554D DIN3
820A-4 820 1600 4150000 690 Bussmann 170M8557D DIN3
880A-4 880 1600 4150000 690 Bussmann 170M8557D DIN3
U
N
= 440…480 V (440, 460, 480 V)
505A-4 505 800 490000 690 Bussmann 170M6812D DIN3
585A-4 585 1000 985000 690 Bussmann 170M6814D DIN3
650A-4 650 1000 985000 690 Bussmann 170M6814D DIN3
725A-4 725 1250 2150000 690 Bussmann 170M8554D DIN3
820A-4 820 1600 4150000 690 Bussmann 170M8557D DIN3
880A-4 880 1600 4150000 690 Bussmann 170M8557D DIN3
3AXD00000586715
Standard drive module configuration (IP00) and option +B051 (IP20 shrounds)
Frame
size
Height Width Depth Weight*
mm in mm in mm in kg lb
R10 1462 57.55 350 13.78 529 20.81 161 355
R11 1662 65.43 350 13.78 529 20.81 199 439
Weight of optional selections
Frame
size
+0H354 +E208 +H356 +0H371 +H370
kg lb kg lb kg lb kg lb kg lb
R10 -7 -15 3 7 2 4 -2.9 -6 2.9 6
R11 -7 -15 3 7 2 4 -2.9 -6 2.9 6
Height of drive module without pedestal (option +H354)
Frame
size
mm in
R10/R11 -100 -3.94