Installation example of drive module with IP20 shrouds (option +B051) 93
Installing the drive module into a cabinet
See appendix Step-by-step drawings for an installation example of drive module with
options +B051 and +E208 in Rittal TS 8 600 mm wide cabinet on page 175 and ACS530-
04 quick installation guide (3AXD50000015469 [English]).
• Install the punched section to the back of the cabinet frame.
• Install the support rails and pedestal guide plate to the cabinet bottom frame.
• Install the telescopic insertion ramp to the pedestal guide plate.
• Remove the sheeting from the clear plastic shrouds from both sides.
• Install the top metallic shroud to the drive module.
• Install the back shrouds to the drive module.
• To prevent the drive module from falling, attach its lifting lugs with chains to the cabinet
frame.
• Push the drive module carefully into the cabinet along the telescopic insertion ramp.
• Remove the ramp.
• Fasten the drive module to the pedestal guide plate.
• Fasten the drive module from top to the punched section at the cabinet back. Note:
The fastening bracket grounds the drive module to the cabinet frame.
• Install the air baffles. See section Preventing the recirculation of hot air on page 45.
Connecting the power cables and installing the shrouds
Step Task (motor cables)
1 Install the grounding terminal to the drive module base.
2 Run the motor cables to the cabinet. Ground the cable shields 360 degrees at the cabinet lead-
through
3 Connect the twisted shields of the motor cables to the grounding terminal
4 Screw in and tighten the insulators to the drive module by hand. Install the T3/W2 connection
terminal to the insulators.
WARNING! Do not use longer screws or bigger tightening torque than given in the
installation drawing. They can damage the insulator and cause dangerous voltage to
be present at the module frame.
5 Connect the phase T3/W2 conductors to the T3/W2 terminal.
6 Install the T2/V2 connection terminal to the insulators See the warning in step 4.
7 Connect the phase T2/V2 conductors to the T2/V2 connection terminal.
8 Install the T1/U2 connection terminal to the insulators. See the warning in step 4.
9 Connect the phase T1/U2 conductors to the T1/U2 terminal.
10 Remove the plastic sheeting from the output clear plastic shroud from both sides.
11 Install the shroud to the drive module.
12 Install the lower front cover to the drive module.
Step Task (input cables)
1 Ground the input cable shields (if present) 360 degrees at the cabinet lead-through.
2 Connect the twisted shields of the input cables and separate ground cable (if present) to the cabinet
grounding busbar.
To Next Page
Loading...
