Note: For information of parameters listed in the diagram, see Parameter
listing (page 53).
Terminal sizes
• (frames R0…R8): 0.14…1.5 mm
2
(all terminals)
• tightening torques: 0.5…0.6 N·m (0.4 lbf·ft)
Notes:
1)
Current [0(4)…20 mA,
R
in
< 500 ohm] or voltage [ 0(2)…10 V,
R
in
> 200 kohm]
input as selected with parameter
12.15 AI1 unit selection
.
2)
Current [0(4)…20 mA,
R
in
= 100 ohm] or voltage[ 0(2)…10 V,
R
in
> 200 kohm]
input as selected with parameter
12.25AI2 unit selection
.
3)
Total load capacity of the auxiliary voltage output+24V (X2:10) = 6.0 W (250 mA
/ 24 V) - User can use this source for either of theI/O connections (DI1... DI2- RO1
or DI3...DI6 - RO2~RO3).
4)
The constant speed are set based on the combination of sources as follows:
Constant speed activeSource defined by parameter
28.23
Source defined by parameter
28.22
Set speed through AI100
Constant frequency 101
Constant frequency 210
5)
The speed reference ramp is set based on the combination of sources as follows:
ParametersRamp setDI5
parameter 28.71
Scalar control (default)
28.72 time 1Acc/Dec time 10
28.73 Freq deceleration time 1
28.74 time 2Acc/Dec time 21
28.75 time 2
6)
Connected with jumpers at the factory.
7)
Applicable for R0~R2 frames only.
8)
Use shielded twisted-pair cables for digital signals.
9)
Ground the outer shield of the cable 360° under the grounding clamp on the
grounding shelf for the control cables.
26 EN - Quick installation and start-up guide
EN
HI
To Next Page
Loading...
