ABB ACS560 - Page 301

Fault / Aux. code
aux code visible
only on assistant
control panel and
drive composer))
(hex)
PLC 
50 (FBA) 51 FBA A .
FBA A 65A1
(//)
EIA-485/X5 29, 30 31
(EFB) EFB 
(Programmable
fault: 58.14
Communication
loss action)
6681
ABB (EFB) EFB 6682
58(EFB) EFB 6683
ABB (EFB) EFB 6684
EFB 
EFB 
EFB 26685
EFB 36686
,ABB 32-6882
,ABB 

6885
PC 7081
IO I/O 7082
7085
AI I/O AI 7086
Check the auxiliary code. See actions
for
I/O module configuration
not supported or illegal.
I/O module
configuration
7087
each code below.
Reboot control unit either by cycling
the power or through parameter
96.08 Control board boot to activate
new DIP switch position.
S1/S2 DIP switch position
on BIO-01 has changed after
power up.
0001
Change S1/S2 DIP switch positions to
a supported combination, see
parameter 05.99 BIO-01 DIP switch
status.
S1/S2 DIP switch positions
are such that DO1 would be
in both S1 and S2 pins. This
is not a supported
combination.
0002
44 

,71A2
44 
()
71A5
 301
EN
HI