ABB ACS560 - Using the Control Panel

￭
Using the control panel
1
2
3
4
5
6
7
8
10
9
Clip – Press the clip downward to remove the panel from the drive.1
Display – Shows basic home view 1 by default. See parameter 49.19 Basic panel
home view 1.
2
RJ-45 connector slot – Located on the back side of the control panel.3
Back button – Moves back to the previous menus. In the Home screen, this button
navigates to the Options menu.
4
OK button – Confirms the selected action.5
Status LEDs –6
• Continuous green – Indicates that drive is functioning normally.
• Blinking green – Indicates an active warning in the drive.
• Continuous red – Indicates an active fault in the drive.
Arrow buttons – Allows scrolling up/down/left/right on text pages. In the Home
screen, the left and right arrow buttons navigate to different (default or user-
defined) home screens (see parameter 49.19 , 49.20 and 49.21 ).
7
Start button– Starts the drive.8
Stop button – Stops the drive.9
Loc/Rem button – Switches between Local/Remote controls. Local control is
through control panel and Remote control is through PC or external devices.
10
EN - Quick installation and start-up guide 35
EN
HI