ABB ACS560 - Page 62

DefaultUnitRange/ListNameIndex
0b0000-0b0000...0b1111RO status10.21
NameBitNameBitNameBitNameBit
Re-
served
3...15RO32RO21RO10
0b0000-See parameter 10.21 RO
status
RO force selection10.22
0b0000-See parameter 10.21 RO
status
RO forced data10.23
Ready run[2]-0...2, 4...24, 27...35,
45...48
RO1 source10.24
RO/DIO control
word bit1[41]
Ext2 active[23]Above limit[12]Not energized[0]
RO/DIO control
word bit2[42]
Remote control[24]Warning[13]Energized[1]
PFC1[45]Timed function
1[27]
Fault[14]Ready run[2]
PFC2[46]Timed function
2[28]
Fault (-1) [15]Enabled[4]
PFC3[47]Timed function
3[29]
Fault/Warning[16]Started[5]
PFC4[48]Reserved[30...32]Overcurrent[17]Magnetized[6]
Event word 1 [53]Supervision 1[33]Overvoltage[18]Running [7]
User load curve[61]Supervision 2[34]Drive temp[19]Ready ref[8]
RO/DIO control
word[62]
Supervision 3[35]Undervoltage[20]At setpoint[9]
Other [bit]Start delay[39]Motor temp[21]Reverse[10]
RO/DIO control
word bit0[40]
Brake com-
mand[22]
Zero speed[11]
0s0.0 … 3000.0RO1 ON delay10.25
0s0.0 … 3000.0RO1 OFF delay10.26
Running [7]-See parameter 10.24
RO1 source
RO2 source10.27
0s0.0 … 3000.0RO2 ON delay10.28
62 Parameter listing
EN
HI