26 Introduction to the manual
Frame (size) Refers to drive physical size, for example R1 and R2. The type
designation label attached to the drive shows the frame of the drive, see
section Type designation key on page 40.
FSCA-01 Optional EIA-485 adapter module
I/O Input/Output
IGBT Insulated gate bipolar transistor
Intermediate circuit See DC link.
Inverter Converts direct current and voltage to alternating current and voltage.
Macro Pre-defined default values of parameters in drive control program. Each
macro is intended for a specific application. See ACS580 firmware
manual (3AXD50000016097[English]).
NETA-21 Remote monitoring tool
Network control With fieldbus protocols based on the Common Industrial Protocol
(CIP
TM
), such as DeviceNet and Ethernet/IP, denotes the control of the
drive using the Net Ctrl and Net Ref objects of the ODVA AC/DC Drive
Profile. For more information, see www.odva.org
, and the following
manuals:
• FDNA-01 DeviceNet adapter module user’s manual (3AFE68573360
[English]), and
• FENA-01/-11/-21 Ethernet adapter module user’s manual
(3AUA0000093568 [English]).
Parameter User-adjustable operation instruction to the drive, or signal measured or
calculated by the drive
PLC Programmable logic controller
PROFIBUS,
PROFIBUS DP,
PROFINET IO
Registered trademarks of PI - PROFIBUS & PROFINET International
PTC Positive temperature coefficient (PTC) refers to materials that
experience an increase in electrical resistance when their temperature
is raised.
R1, R2, … Frame (size)
Rectifier Converts alternating current and voltage to direct current and voltage.
SIL Safety integrity level. See chapter Safe torque off function on page 231.
STO Safe torque off. See chapter Safe torque off function on page 231.
Term/abbreviation Explanation
To Next Page
Loading...
