ABB ACS580-01 - External Control Connection Terminals, Frames R1

Operation principle and hardware description 35
 External control connection terminals, frames R1…R5
The layout of the external control connection terminals of the R1 frame is shown
below. Layout of the external control connection terminals is identical in frames
R1…R5 but the location of the control board with the terminals is different in frames
R3…R5.
Description
X1 Analog inputs and outputs
X2 Aux. voltage output
X3 Programmable digital inputs
X4 Safe torque off connection
X5 Embedded fieldbus
X6 Relay output 3
X7 Relay output 2
X8 Relay output 1
X10 Auxiliary fan connection (IP55)
X13 Option slot 1 (fieldbus adapter
modules)
X14 Option slot 2 (I/O extension
modules)
S4, S5 Termination switch (S4), bias
resistor switch (S5), see section
Switches on page 120
1 Panel port (control panel
connection)
2 Cold configuration connection. This
connector is used with the CCA-01
configuration adapter.
3 Power OK and Fault LEDs. See
section LEDs on page 156.
1
2
3
S4
X5
S5
X13
X14
X3
X2
X4
X1
X6
X7
X8
X10
R1…R5