ABB ACS580-01 - Installing the Drive; Installing the Drive Vertically, Frames R1

Mechanical installation 57
Installing the drive
 Installing the drive vertically, frames R1…R4
The figures show frame R3 as an example.
1. Mark the hole locations using the mounting template included in the package. Do
not leave the mounting template under the drive. The drive dimensions and hole
locations are also shown in the drawings in chapter Dimension drawings on page
203.
2. Drill the mounting holes.
3. Insert anchors or plugs into the holes and start the screws or bolts into the
anchors or plugs.
Use a sufficient number of screws or bolts and drive them long enough into the
wall to make them carry the weight of the drive.
R1 R2 R3 R4
mm in mm in mm in mm in
a 98 3.86 98 3.86 160 6.30 160 6.30
b 317 12.48 417 16.42 473 18.62 619 24.37
Weight
IP21 (UL Type1)
kg lb kg lb kg lb kg lb
4.8 10.59 6.5 14.33 11.80 26.02 19 41.90
Weight
IP55 (UL Type12)
kg lb kg lb kg lb kg lb
5.1 11.25 6.7 14.80 13.00 28.67 20 44.10
a
b
1 2 3
×4
×4
R3…R4: M6
×4