60 Mechanical installation
IP21 (UL Type 1)
4. Remove the front cover: Remove the fastening screws (4a) and lift the cover from
the bottom upwards (4b) and then to the top side (4c).
5. Attach the cable box to the drive frame.
6. Tighten the box screws.
7. Slide the box cover from the bottom (7a) and tighten the retaining screws (7b).
8. Put the tabs at the top of the front cover in their counterparts on the housing and
then press at the bottom (8a) and tighten the retaining screws (8b).
To Next Page
Loading...
