ABB ACS580-01 - Installing the Drive Vertically, Frames R6

62 Mechanical installation
 Installing the drive vertically, frames R6…R9
1. Mark the hole locations for the six mounting holes using the mounting template
included in the package. Do not leave the mounting template under the drive.
The drive dimensions and hole locations are also shown in the drawings in
chapter Dimension drawings on page 203.
Note: You can use only two bolts instead of four to attach the lower part of the drive.
2. Drill the mounting holes.
3. Insert fixing anchors or plugs into the holes and start the bolts into the anchors or
plugs.
Use a sufficient number of bolts and drive them long enough into the wall to make
them carry the weight of the drive.
4. Position the drive onto the bolts on the wall. Lift the drive with another person as it
is heavy.
5. Tighten the bolts in the wall securely.
c
a
d
e
b
R6 R7 R8 R9
mm in mm in mm in mm in
a 571 22.5 623 24.5 701 27.6 718 28.3
b 531 20.9 583 22.9 658 25.9 658 25.9
c 213 8.4 245 9.7 263 10.4 345 13.6
d 300 11.8 300 11.8 300 11.8 300 11.8
e 200 7.9 200 7.9 200 7.9 200 7.9
IP21,
UL Type 1
kg lb kg lb kg lb kg lb
42 93.5 54 119 69 152 97 213.9
IP55,
UL Type 12
kg lb kg lb kg lb kg lb
43 94.8 56 123.5 77 169.8 103 227.1
1
× 4
3
× 2 × 2
4 2
5
M8