ABB ACS580-01 - Installing the Drive Vertically Side by Side; Installing the Drive Horizontally, Frames R1

Mechanical installation 63
IP21 (UL Type 1)
6. Remove the front cover: Remove the fastening screws (a), move the cover to the
top side (b) and then up (c).
7. Attach the cable box to the drive frame.
8. Tighten the box screws: two at the top and four at the bottom.
IP55 (UL Type 12)
9. Remove the front cover: Remove the fastening screws (a), move the cover to the
top side (b) and then up (c).
 Installing the drive vertically side by side
Install the drive following the steps in the appropriate section Installing the drive
vertically, frames R1…R4 (page 57), Installing the drive vertically, frame R5 (page 59)
or Installing the drive vertically, frames R6…R9 (page 62).
 Installing the drive horizontally, frames R 1 …R3
Install the drive following the steps in the appropriate section Installing the drive
vertically, frames R1…R4 (page 57). The drive can be installed either the left or right
side up.
6a
7
8
8
M8×6
6a
6b
6c
6a
6a
6b
6c