General safety in installation, start-up and maintenance
These instructions are for all personnel who do work on the drive.
WARNING!
Obey these instructions. If you ignore them, injury or death, or damage to the
equipment can occur.
• Keep the drive in its package until you install it. After unpacking, protect the drive from
dust, debris and moisture.
• Use the required personal protective equipment: safety shoes with metal toe cap, safety
glasses, protective gloves, etc.
• Lift a heavy drive with a lifting device. Use the designated lifting points. See the dimension
drawings.
• Secure the drive cabinet to the floor to prevent it from toppling over. The cabinet has a
high center of gravity. When you pull out heavy components or power modules, there
is a risk of overturning. Secure the cabinet also to the wall when necessary.
• Do not stand or walk on the cabinet roof. Make sure that nothing presses against the
roof, side or back plates or door. Do not store anything on the roof while the drive is in
operation.
• Frames R10 and R11: Do not use the module installation ramp with plinth heights which
exceeds the maximum allowed height. See the technical data.
• Frames R10 and R11: Secure the module extraction/installation ramp carefully.
• Frames R10 and R11: To prevent the drive module from falling, attach its top lifting lugs
with chains to the cabinet lifting lug before you push the module into the cabinet and
pull it from the cabinet. Push the module into the cabinet and pull it from the cabinet
carefully preferably with help from another person. Keep a constant pressure with one
foot on the base of the module to prevent the module from falling on its back. Make
sure that the module does not topple over when you move it on the floor. To extend the
support legs, press each leg a little down (1, 2) and turn it aside. Whenever possible
secure the module also with chains. The module overturns from a sideways tilt of 5
degrees.
16 Safety instructions
To Next Page
Loading...
