ABB ACS580-07 - Markings; CE Marking; Compliance with the European Low Voltage Directive; Compliance with the European EMC Directive

Markings
CE mark
Product complies with the applicable European Union legislation. For fulfilling the EMC requirements,
see the additional information concerning the drive EMC compliance (IEC/EN 61800-3).
UL listed mark for USA and Canada
Product has been tested and evaluated against the relevant North American standards by the Un-
derwriters Laboratories.
RCM mark
Product complies with Australian and New Zealand requirements specific to EMC, telecommunica-
tions and electrical safety. For fulfilling the EMC requirements, see the additional information con-
cerning the drive EMC compliance (IEC/EN 61800-3).
EAC (Eurasian Conformity) mark
Product complies with the technical regulations of the Eurasian Customs Union. EAC mark is required
in Russia, Belarus and Kazakhstan.
Electronic Information Products (EIP) green mark
The product complies with the People’s Republic of China Electronic Industry Standard (SJ/T 11364-
2014). The product does not contain toxic and hazardous substances or elements above the max-
imum concentration values, and it is an environmentally-friendly product which can be recycled.

CE marking
A CE mark is attached to the drive to verify that the drive complies with the provisions of
the European Low Voltage and EMC Directives. The CE marking also verifies that the drive,
in regard to its safety functions (such as Safe torque off), conforms with the Machinery
Directive as a safety component.
￭ Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has been verified according to
standard EN 61800-5-1.
￭ Compliance with the European EMC Directive
The EMC Directive defines the requirements for immunity and emissions of electrical
equipment used within the European Union. The EMC product standard (EN 61800-3:2004)
covers requirements stated for drives. See section Compliance with the EN 61800-3:2004
below.
￭ Compliance with the European Machinery Directive
The drive is an electronic product which is covered by the European Low Voltage Directive.
However, the drive includes the Safe torque off function and can be equipped with other
safety functions for machinery which, as safety components, are in the scope of the
Machinery Directive. These functions of the drive comply with European harmonized
standards such as EN 61800-5-2. The declaration of conformity is shown below.
216 Technical data