Terminal designations (page 273)
3-pin terminal block for transistor output4
Terminal designations (page 273)
2-pin terminal block for external power supply5
LEDs (page 277)
Diagnostic LED6
￭ Mechanical installation
Necessary tools and instructions
• Screwdriver and a set of suitable bits.
Unpacking and checking the delivery
1. Open the option package.
2. Make sure that the package contains:
• CMOD-01 multifunction extension module
• a mounting screw
• support part
Note:
The support part is needed for the following frame R1 drive types -02A7, -03A4,
-04A1, -05A7, -08A5 and -12A7.
3. Make sure that there are no signs of damage.
Installing the module
See section Installing optional modules in chapter Electrical installation.
￭ Electrical installation
WARNING!
Obey the instructions in chapter Safety instructions. If you ignore them, injury or
death, or damage to the equipment can occur. If you are not a qualified electrician,
do not do electrical work.
Make sure that the drive is disconnected from the input power during
installation. If the drive is already connected to the input power, wait for
5 minutes after disconnecting the input power.
Necessary tools and instructions
• Screwdriver and a set of suitable bits
• Cabling tools
Terminal designations
For more detailed information on the connectors, see section Technical data (page 278).
Relay outputs
DescriptionMarking
Common, CRO4C50
Normally closed, NCRO4A51
Normally open, NORO4B52
Common, CRO5C53
Optional I/O extension modules 273
To Next Page
Loading...
