Do not install the drive on an elevated platform or a recess. The module extraction/installation
ramp included with the drive is only suitable for a height difference of 50 mm maximum (ie.
the standard plinth height of the drive).
Necessary tools
The tools required for moving the unit to its final position, fastening it to the floor and wall
and tightening the connections are listed below:
• crane, fork-lift or pallet truck (check load capacity!), slate/spud bar, jack and rollers
• Pozidriv and Torx screwdrivers
• torque wrench
• set of wrenches or sockets.
52 Mechanical installation
To Next Page
Loading...
