5. Prepare the ends of the motor cable as illustrated in figures 5a and 5b (two
different motor cable types are shown). If you use aluminum cables, put grease
to the peeled aluminum cable before connecting it to the drive.
Note: The bare shield will be grounded 360 degrees. Mark the pigtail made
from the shield as a PE conductor with yellow-and-green color.
6. Slide the cable through the hole of the bottom plate and attach the grommet
to the hole.
7. Connect the motor cable:
• Ground the shield 360 degrees by tightening the clamp of the power cable
grounding shelf onto the stripped part of the cable (7a).
• Connect the twisted shield of the cable to the grounding terminal (7b).
• Connect the phase conductors of the cable to the T1/U, T2/V and T3/W
terminals (7c). Tighten the screws to the torque given in the table.
150 Electrical installation – Global (IEC)
To Next Page
Loading...
