10. Install the cable box plate. Position the plate (10a) and tighten the screw (10b).
PE,
L1, L2, L3Frame size
lbf·ftN·mlbf·ftN·mMlbf·ftN·m
0.91.21.62.2M511.115R5
11. Reinstall the shroud on the power terminals by putting the tabs at the top of
the shroud in their counterparts on the drive frame (11a) and then pressing
the shroud in place (11b).
Finalization
12. Secure the cables outside the unit mechanically.
152 Electrical installation – Global (IEC)
To Next Page
Loading...
