ABB ACS580 Series - Brake Resistor Cabling (if Used)

R4R4 v2
L1
L2
L3
R+
UDC+
R-
T1/U T2/V T3/W
10a
10b
L1
L2
L3
R+
UDC+
R-
T1/U T2/V T3/W
10 a
10 b
R4 v2R4R3R2R1Frame size
lbf·ftN·mlbf·ftN·mlbf·ftN·mlbf·ftN·mlbf·ftN·m
4.05.53.04.02.63.51.11.50.71.0L1, L2, L3
2.12.92.12.91.11.51.11.51.11.5
PE,
Brake resistor cabling (if used)
Frames R1…R3 only:
11. Repeat steps 8…9 for the brake resistor conductors. Use only two phase
conductors and the ground conductor.
11
Conduit
12. Connect the grounding conductor to the grounding terminal (12a) and the
other conductors to the R+ and R- terminals (12b). Tighten the screws to the
torque given in the table.
192 Electrical installation – North America