4. Remove the rubber grommets, if present, for the motor and input power
cabling.
Remove the grommets for the control cabling when you are connecting them.
5. Prepare the power cables as in Connection procedure, frames R1…R4 (page 186),
step 4
Note: If the drive is shipped with grommet cones pointing up they must be
removed and inserted back pointing down.
Motor cabling
6. Prepare the ends of the cable as illustrated in the figure.
Note: The bare shield will be grounded 360 degrees. Mark the pigtail made
from the shield as a PE conductor with yellow-and-green color.
7. Slide the cable through the hole of the bottom plate and attach the grommet
to the hole.
8. Connect the motor cable:
Electrical installation – North America 195
To Next Page
Loading...
