• Ground the shield 360 degrees by tightening the clamp of the power cable
grounding shelf onto the stripped part of the cable (8a).
• Connect the twisted shield of the cable to the grounding terminal (8b).
• Connect the phase conductors of the cable to the T1/U, T2/V and T3/W
terminals (8c). Tighten the screws to the torque given in the table.
PE,
T1/U, T2/V, T3/WFrame
size
lbf·ftN·mMlbf·ftN·m
1.62.2M511.115R5
Input power cabling
9. Strip the ends of the conductors.
10. Slide the conductors through the conduit.
11. Connect the conductors:
• Connect the grounding conductor to the grounding terminal. (11a)
• Connect the conductors as for the motor cabling. Use terminals L1, L2 and
L3 (11b). Tighten the screws to the torque given in the table.
12. Install the cable box plate. Position the plate (12a) and tighten the screw (12b).
196 Electrical installation – North America
To Next Page
Loading...
