ABB ACS580 Series - Leds; Drive Leds

LEDs
￭
Drive LEDs
There is a green POWER and a red FAULT LED on the front of the drive. They are
visible through the panel cover but invisible if a control panel is attached to the
drive. The table below describes the drive LED indications.
Drive LEDs POWER and FAULT, on the front of the drive, under the control panel / panel
cover
If a control panel is attached to the drive, switch to remote control (otherwise a fault
will be generated), and then remove the panel to be able to see the LEDs
LED blinkingLED lit and steadyLEDs
off
Blinking:
Drive in an alarm state
Green
(POWER)
Power supply on the board OKGreen
(POWER)
No
power
Blinking for one second:
Drive selected on the control
panel when multiple drives are
connected to the same panel
bus.
Active fault in the drive. To re-
set the fault, switch off the
drive power.
Red
(FAULT)
Active fault in the drive. To re-
set the fault, press RESET from
the control panel or switch off
the drive power.
Red
(FAULT)
262 Maintenance