ABB ACS580 Series - Terminal and Entry Data for the Power Cables; Iec

Terminal and entry data for the power cables
￭
IEC
Input (except IP66 (UL Type 4X) with disconnect), motor, resistor and DC cable
entries, maximum wire sizes (per phase) and terminal screw sizes and tightening
torques ( T ) are given below.
Grounding terminalsL1, L2, L3, T1/U, T2/V, T3/W terminalsCable
entries
Frame
size
T Max wire size T Max wire size
(solid/stranded)
Min wire size
(solid/stran-
ded)
2)
Ø
1)
Per
cable
type
N·mmm
2
N·mmm
2
mm
2
mmpcs
3-phase U
n
= 230 V
1.516/161.06/40.2/0.2301R1
1.516/161.516/160.5/0.5301R2
1.535/353.535/350.5/0.5301R3
2.935/355.5701.5/1.5451R4 v2
2.2-15706451R5
9.81803015025451R6
9.81804024095541R7
9.8180402×1502×50452R8
3-phase U
n
= 400 or 480 V
1.516/161.06/40.2/0.25301R1
1.516/161.516/160.5/0.5301R2
1.535/353.535/250.5/0.5301R3
2.935/354.0500.5/0.5451R4
2.935/355.5701.5/1.5451R4 v2
2.2
35/35
3)
15706451R5
9.8
185
3)
3015025451R6
9.8
185
3)
4024095541R7
9.8
2×185
3)
402×1502×50452R8
9.8
2×185
3)
702×2402×95542R9
1)
Maximum cable diameter accepted. For the entry plate hole diameters, see chapter Dimension
drawings (page 363).
330 Technical data