ABB ACS580 Series - Page 336

R+, R-, UDC+ and UDC- terminalsCable entriesFrame
size
T
Wire range size (stranded/solid)
2)
Ø
1)
Per cable
type
lbf·ftScrew/BoltMaxMin
AWGAWGinpcs
0.7
3)
10241.111R1
1.1
3)
6201.111R2
2.6
3)
2201.381R3
3.0
3)
1201.731R4
4.1
3)
1201.731R4 v2
11.1M51/061.731R5
22.1M8300 MCM41.971R6
29.5M10500 MCM3/02.441R7
29.5M102×300 MCM2×1/02.442R8
51.6M122×500 MCM2×3/02.442R9
3-phase U
1
= 525…600 V, P
n
at U
n
= 575 V, 60 Hz
1.1
3)
6201.111R2
2.6
3)
2201.381R3
11.1M51/061.731R5
29.5M10500 MCM3/02.441R7
29.5M102×300 MCM2×1/02.442R8
51.6-2×500 MCM2×3/02.442R9
1)
Diameter of the cable entry plate hole.
2)
Note: Minimum wire size does not necessarily have enough current capability for full load.Make sure
the installation complies with local laws and regulations.
3)
See the table below
Screwdrivers for the terminals of the main circuitFrame size
Combo: Slot 4 mm and PH1R1
Combo: Slot 4.5 mm and PH2R2
PH2R3, R4
TorxR4 v2
336 Technical data