ABB ACS580 Series - External Control Connection Terminals, Frames R6

￭
External control connection terminals, frames R6…R9
The layout of the external control connection terminals of frames R6…R9 is shown
below.
Description
Analog inputs and outputsX1
Aux. voltage outputX2
Digital inputsX3
Safe torque off connectionX4
Connection to embedded EIA-485
fieldbus adapter module
X5
Relay output 3X6
Relay output 2X7
Relay output 1X8
External +24 V AC/DC input connectionX10
Panel connectionX12
Option slot 1 (fieldbus adapter mod-
ules)
X13
Option slot 2 (I/O extension modules)X14
Auxiliary fan 1 connectionX16
Auxiliary fan 2 connectionX17
Air in temperature sensor connectionX18
Termination switch (S4), bias resistor
switch (S5), see Embedded EIA-485
fieldbus connection (page 223)
S4,
S5
Panel port (control panel connection)1
Cold configuration connection. This
connector is used with the CCA-01 con-
figuration adapter.
2
Power OK and Fault LEDs. See section
LEDs (page 262).
3
2
R6…R9
X2
X4
X13
1
3
X8
X7
X6
X10
X5
S4, S5
X17X16
X14
X1:1…3
X1:4…6
X1:7…9
X3:1…3
X3:4…6
X12
X18
WARNING!
Do not connect the +24 V AC cable to the control unit ground when the control
unit is powered from an external 24 V AC supply.
50 Operation principle and hardware description