ABB ACS580 - Page 150

146 Parameters
46 Monitoring/scaling settings Speed supervision settings; actual signal filtering; general scaling
settings.
297
47 Data storage Data storage parameters that can be written to and read from
using other parameters’ source and target settings.
300
49 Panel port communication Communication settings for the control panel port on the drive. 301
50 Fieldbus adapter (FBA) Fieldbus communication configuration. 302
51 FBA A settings Fieldbus adapter A configuration. 306
52 FBA A data in Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter A.
307
53 FBA A data out Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter A.
308
58 Embedded fieldbus Configuration of the embedded fieldbus (EFB) interface. 308
71 External PID1 Configuration of external PID. 315
76 PFC configuration PFC (Pump and fan control) and Autochange configuration
parameters. See also section Pump and fan control (PFC) on
page 103.
318
77 PFC maintenance and
monitoring
PFC (Pump and fan control) and Autochange configuration
parameters. See also section Pump and fan control (PFC) on
page 103.
323
95 HW configuration Various hardware-related settings. 324
96 System Language selection; access levels; macro selection; parameter
save and restore; control unit reboot; user parameter sets; unit
selection.
326
97 Motor control Switching frequency; slip gain; voltage reserve; flux braking; anti-
cogging (signal injection); IR compensation.
333
98 User motor parameters Motor values supplied by the user that are used in the motor
model.
336
99 Motor data Motor configuration settings. 337
Group Contents Page
ACS580 FW.book Page 146 Wednesday, September 21, 2016 9:48 PM