ABB ACS580MV - Cable Requirements; Parallel Routing of Power Cables; Terminal Sizes for Auxiliary and Control Connections

66 Electrical installation
Cable requirements
For information on the requirements for power cables and the ground cable see the
ACS580MV Engineering Guideline
For information on the requirements for the auxiliary power cable and the control cables,
see Auxiliary power and control cables guideline.
Parallel routing of power cables
Cables between drive and motor can be laid in parallel. The number of cables laid in
parallel is limited by the number of entry holes of the entry plate.
For information on the supply voltages, see Rating label of the drive.
Terminal sizes for auxiliary and control connections
Customer I/O terminal
Terminal
Wire cross-section (mm
2
)
Solid wire Flexible wire
X1:1
0.2...2.5 mm
2
X1:3
X1:5
X1:7
X1:9
X1:11
X1:13
X1:15
X1:17
X1:19
X1:21
X1:23
X1:25
X1:27
X1:29
X1:31
X1:33
X1:35
X1:37
X1:39
X1:41
X1:43
X1:45
X1:47
X1:49
X1:51
Customer supply connection terminals
Terminal
Wire cross section (mm
2
)
Solid wire Flexible wire
X4: N
X4: PE
0.5...4 mm
2
X5: N
X5: PE
0.5...4 mm
2
X6: N
X6: PE
1.5...35 mm
2