28 Operation principle and hardware description
Note: Type code +0N664 means that the drive module has been installed inside a cabinet at the factory.
This type code is for ABB internal use only.
Type code for ACS800-04M non-pre-assembled units (delivered as kits)
Selection Alternatives
Product series ACS800 product series
Type 04M Drive module. When no options are selected: 6-pulse diode input
bridge, IP00, top entry of cables, RDCU drive control unit, no
control panel, no EMC filter, Standard Control Program, no
pedestal, no output busbars, one set of manuals.
Size Refer to
IEC data
(page 99) or
NEMA data
(page 114).
Voltage range
(nominal rating in bold)
2 208/220/230/240 VAC
3380/400/415 VAC
5 380/400/415/440/460/480/500 VAC
7 525/575/600/690 VAC
Option codes (+ codes)
Shrouds B060 Frame size R7:
clear plastic shrouds for bottom exit kit (+H352)
and input terminals.
Frame size R8:
clear plastic shrouds for vertical busbars and input
terminals in bookshelf mounting (+H354 and +H355)
Resistor braking D150 brake chopper
Filter E202 EMC/RFI filter for first environment TN (grounded) system,
restricted (the A limits)
E210 EMC/RFI filter for second environment TN/IT
(grounded/ungrounded) system
E208 common mode filter
Pedestal and output
busbars
H352 bottom exit kit for frame size R7
H354 pedestal with output on the long side (bookshelf)
H355 vertical busbars and support brackets for AC output connection
H356 pedestal (and adapter with +H360) busbar kit for brake resistor
and DC connection
H360 pedestal with output on the short side (flat)
H362 vertical busbars (and support brackets with +H360) for DC output
connection
H363 busbar kit for DC and brake outputs on different long sides of the
pedestal (+H356 required, not available for +H360)
Control panel J400 CDP 312R control panel including a 3-meter panel connection cable
J410 RPMP-11 control panel mounting platform kit including a 3-meter
panel connection cable but no control panel
J413 RPMP-21 control panel holder
Fieldbus K... Refer to
ACS800 Ordering Information
(3AFY64556568).
I/O L...
Control program N...
Language of manual R...
Specialties P901 coated boards
P904 extended warranty
Safety features Q950 Prevention of unexpected start-up (not to be used with +Q967),
including 500 mm (19.68 in.) cable outside the drive module in
frame size R7, 600 mm (23.62 in.) cable outside the drive module in
frame size R8.
Q967 Safe torque off (STO) (not to be used with +Q950), including
500 mm (19.68 in.) cable outside the drive module in frame size R7,
600 mm (23.62 in.) cable outside the drive module in frame size R8.
To Next Page
Loading...
