Maintenance
131
Inserting the module into the cubicle
1. Move the module close to the ramp, and then retract the support legs of the
module.
2. Push the module up the ramp and back into the cubicle.
WARNING! Keep your fingers away from the edge of the module front plate to avoid
pinching them between the module and the cubicle. Also, keep a constant pressure
with one foot on the base of the module to prevent the module from falling on its
back.
3. Fasten the module fixing screws at the top and reconnect the DC busbars.
4. Connect the cables (X50, fibre optic cables).
5. Loosen the fastening screws at the base of the module and remove the pull-out
ramp. Flip the module fastening bracket into the down position and tighten the
screws.
6. Fasten the shroud and close the cubicle door.
To Next Page
Loading...
