ABB ACS800 Series - Drive Selection Mode; How to Select a Drive and Change Its Panel Link ID Number

Control panel
20
Drive selection mode
In normal use the features available in the Drive Selection Mode are not needed; the
features are reserved for applications where several drives are connected to one
panel link. (For more information, see Installation and Start-up Guide for the Panel
Bus Connection Interface Module, NBCI, Code: 3AFY58919748).
In the Drive Selection Mode, the user can:
• Select the drive with which the panel communicates through the panel link.
• Change the identification number of a drive or panel connected to the panel link.
• View the status of the drives connected on the panel link.
The panel enters the Drive Selection Mode when the user presses the DRIVE key.
Each on-line station must have an individual identification number (ID). By default,
the ID number of the drive is 1.
Note: The default ID number setting of the drive should not be changed unless the
drive is to be connected to the panel link with other drives on-line.
How to select a drive and change its panel link ID number
Step Action Press Key
Display
1. To enter the Drive Selection Mode. ACS 800 75 kW
ASAAA5000 xxxxxx
ID NUMBER 1
2. To select the next drive/view.
The ID number of the station is changed
by first pressing ENTER (the brackets
round the ID number appear) and then
adjusting the value with double-arrow
buttons. The new value is accepted with
ENTER. The power of the drive must be
switched off to validate its new ID number
setting.
ACS 800 75 kW
ASAAA5000 xxxxxx
ID NUMBER 1
The status display of all devices
connected to the Panel Link is shown after
the last individual station. If all stations do
not fit on the display at once, press the
double-arrow up to view the rest of them.
Status Display
Symbols:
= Drive stopped,
direction forward
= Drive running,
direction reverse
F = Drive tripped
on a fault
3. To connect to the last displayed drive and
to enter another mode, press one of the
mode selection keys.
The selected mode is entered.
1 L -> 1242.0 rpm
I
F
REQ 45.00 Hz
CURRENT 80.00 A
POWER 75.00 %
DRIVE
1o
o
PAR
FUNC
ACT