Application macros
54
The drive is speed controlled and uses the dancer position feedback to regulate the
web tension to the midpoint. To properly operate in this mode the following
parameters must be set up:
62.05 RANGE ADJUST
62.06 TRIM REG REL TO
62.09 DANCER CTL ENABLE - must be active for the PI regulator to operate
62.11 DANCER FDBK INPUT
62.14 MAX DANCER TRAVEL
62.15 CENTER OFFSET
If the dancer loading is being controlled by the drive, the following parameters must
also be set up:
62.10 DANCER LOAD SETPT
62.12 TAPER REF SELECT
62.13 MAX TAPER/%TAPER - if no taper is desired, set this to 0%
To Next Page
Loading...
