ABB ACS880-01 - Introduction to the manual; What this chapter contains; Applicability; Target audience

66
Additional requirements for ABB motors of types other than M2_,
M3_, M4_, HX_ and AM_ .................................................................
66Additional requirements for braking applications ..............................
66Additional requirements for ABB high-output and IP23 motors ........
67Additional requirements for non-ABB high-output and IP23 motors ..
68
Additional data for calculating the rise time and the peak line-to-line
voltage ..............................................................................................
69Additional note for sine filters ...........................................................
69Selecting the power cables .................................................................................
69General guidelines .......................................................................................
70Typical power cable sizes ............................................................................
71Power cable types ........................................................................................
71Preferred power cable types .............................................................
72Alternate power cable types .............................................................
73Not allowed power cable types .........................................................
73Additional guidelines, North America ...........................................................
74Metal conduit ....................................................................................
74Power cable shield .......................................................................................
75Selecting the control cables ................................................................................
75Shielding ......................................................................................................
75Signals in separate cables ...........................................................................
75Signals that can be run in the same cable ...................................................
75Relay cable ..................................................................................................
75Control panel to drive cable .........................................................................
75PC tool cable ................................................................................................
76Routing the cables ..............................................................................................
76General guidelines – IEC .............................................................................
76General guidelines – North America ............................................................
77
Continuous motor cable shield/conduit or enclosure for equipment on the
motor cable ..................................................................................................
78Separate control cable ducts .......................................................................
78Implementing short-circuit and thermal overload protection ...............................
78Protecting the drive and the input power cable in short-circuits ...................
79Protecting the motor and motor cable in short-circuits .................................
79Protecting the motor cables against thermal overload .................................
79Protecting the motor against thermal overload ............................................
79
Protecting the motor against overload without thermal model or temperature
sensors using an external overload device ..................................................
80Protecting the drive against ground faults ..........................................................
80Residual current device compatibility ...........................................................
80Connecting drives to a common DC system .......................................................
80Implementing the emergency stop function ........................................................
80Implementing the Safe torque off function ..........................................................
80Implementing the functions provided by the FSO-xx safety functions module ....
81Implementing an ATEX-certified motor thermal protection .................................
Table of contents 7