9. Unplug the cabinet fan power supply cables and remove the fan assembly above the
drive module.
10. Unplug the wire terminals and remove the mounting plate.
11. Disconnect the power cabling busbars from the drive module terminals.
12. Remove the slide extension rails (attached to the slide rails) by undoing the mounting
screws. Install the extension rails at the end of the sliding rails.
13. Undo the upper mounting nuts of the drive module.
14. Undo the lower mounting nuts of the drive module.
15. Remove the two mounting screws of the top right mountig plate. Turn the plate to the
horizontal position.
16. Slide the drive module towards the end of the sliding bars.
17. Secure the drive module with chains from the lifting eyes.
18. Lift the module out of the cabinet with the lifting device.
19. Install the new module in reverse order.Undo the hinge screw at the top and bottom of
the swing-out frame to enable the frame to open aside far enough.
182 Maintenance
To Next Page
Loading...
