WARNING!
• Do not use the module extraction/installation ramp with plinth heights which
exceeds the maximum allowed height. See the technical data.
• Attach the module extraction/installation ramp carefully.
• Make sure that the module does not topple over when you move it on the floor:
To open the support legs, press each leg a little down and turn it aside (1, 2).
Whenever possible attach the module also with chains. Do not tilt the drive
module. It is heavy and its center of gravity is high. The module overturns from
a sideways tilt of 5 degrees. Do not leave the module unattended on a sloping
floor.
• To prevent the drive module from falling, attach its top lifting lugs with chains
to the cabinet (1) before you push the module into the cabinet and pull it from
the cabinet. Push the module into the cabinet and pull it from the cabinet
carefully preferably with help from another person. Keep a constant pressure
with one foot on the base of the module (2) to prevent the module from falling
on its back.
186 Maintenance
To Next Page
Loading...
