ABB ACS880-11 - Installation Next to the Control Unit on Frames R6 and R8

8. Connect the Safe torque off (STO) cable to connector X111 on the module and to
connector XSTO on the drive module control unit as shown in Wiring (page 211).
9. Connect the external +24 V power supply cable to connector X112.
10.
Connect the other wires as shown in FSO-12 safety functions module user’s manual
(3AXD50000015612[English]) or in FSO-21 safety functions module user’s manual
(3AXD50000015614 [English]).
3
5
5
5
5
6
X12
Installation next to the control unit on frames R6 and R8
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur.
1.
Stop the drive and do the steps in section Electrical safety precautions (page 15).
2. Remove the front cover.
3. Insert the module carefully into its position.
Electrical installation – IEC 107