10
Start-up
Contents of this chapter
This chapter describes the start-up procedure of the drive.
Start-up procedure
1. Run setup of the drive control program according to the start-up instructions given
in ACS880 with primary control program quick start-up guide (3AUA0000098062
[English]) or in the firmware manual.
•
For drives with ABB sine filter: Check that parameter 95.15 Special HW settings
is set to ABB sine filter.
For other sine filters: See Sine filter hardware manual (3AXD50000016814
[English]).
•
For drives with ABB motors in explosive atmospheres: See ACS880 drives with
ABB motors in explosive atmospheres supplement (3AXD50000019585
[English]).
2. Validate the Safe torque off function according to the instructions given in chapter
The Safe torque off function (page 209).
3. Validate the safety functions (options +Q923, +Q973 and +Q982) as described in
FSO-12 safety functions module user's manual (3AXD50000015612 [English]),
FSO-21 safety functions module user's manual (3AXD50000015614 [English]) or
FSPS-21 PROFIsafe safety functions module user's manual (3AXD50000158638
[English]).
Start-up 141
To Next Page
Loading...
