14 Safety instructions
General safety in installation, start-up and maintenance
These instructions are for all personnel that install the drive and do maintenance work on
it.
WARNING! Obey these instructions. If you ignore them, injury or death, or
damage to the equipment can occur.
• Secure the cabinet to the floor to prevent it from toppling over when you pull out drive
and LCL filter modules. The modules are heavy and have a high center of gravity.
• Wear protective gloves and long sleeves. Some parts have sharp edges.
• Handle the drive and LCL filter modules carefully:
• Use safety shoes with a metal toe cap to avoid foot injury.
• Lift the module with a lifting device only. Use the designated lifting points.
• Frame R11:
• Do not tilt the module. It is heavy and its center of gravity is high.
• Make sure that the module does not topple over when you move it on the floor: Do not leave
the module unattended on a sloping floor. Extend the support legs: Press each leg a little down
and turn it aside. Whenever possible secure the module also with chains.
• Do not use the module installation ramp with plinth heights which exceed the maximum height
marked on the ramp. (The maximum plinth height is 50 mm [1.97 in] when the telescopic ramp
is fully retracted and 150 mm [5.91 in] when the ramp is fully extended.)
• Secure the module installation ramp carefully.
To Next Page
Loading...
