Technical data 175
Package Standard package:
• timber, polyethylene sheet (thickness 0.15 mm), stretch film (thickness
0.023 mm), PP tape, PET strap, sheet metal (steel)
• for land and air transport when planned storage time is less than 2 months or
when storage can be arranged in clean and dry conditions less than 6 months
• can be used when products will not be exposed to corrosive atmosphere
during transport or storage
Container package:
• timber, VCI sheet film (PE, thickness 0.10 mm), VCI stretch film (PE,
thickness 0.04 mm), VCI emitter bags, PP tape, PET strap, sheet metal (steel)
• for sea transport in containers
• recommended for land and air transport when storage time prior to installation
exceeds 6 months or storage is arranged in partially weather-protected
conditions
Seaworthy package:
• timber, plywood, VCI sheet film (PE, thickness 0.15 mm), VCI stretch film (PE,
thickness 0.04 mm), VCI emitter bags, PP tape, PET strap, sheet metal (steel)
• for sea transport with or without containerization
• for long storage periods in environments where roofed and humidity-
controlled storage cannot be arranged
Cabinets are fastened to the pallet with screws and braced from the top end to
the package walls to prevents swaying inside the package. Package elements
are attached together with screws. For handling the packages, see section
Moving and unpacking the drive on page 57.
Disposal The main parts of the drive can be recycled to preserve natural resources and
energy. Product parts and materials should be dismantled and separated.
Generally all metals, such as steel, aluminum, copper and its alloys, and
precious metals can be recycled as material. Plastics, rubber, cardboard and
other packaging material can be used in energy recovery. Printed circuit boards
and large electrolytic capacitors need selective treatment according to
IEC 62635 guidelines. To aid recycling, plastic parts are marked with an
appropriate identification code.
Contact your local ABB distributor for further information on environmental
aspects and recycling instructions for professional recyclers. End of life
treatment must follow international and local regulations.
Applicable standards
The drive complies with the standards below. The compliance with the European
Low Voltage Directive is verified according to standard EN 61800-5-1.
European electrical safety requirements product standards
EN 61800-5-1:2007 Adjustable speed electrical power drive systems. Part 5-1: Safety requirements
– electrical, thermal and energy
IEC 60146-1-1:2009
EN 60146-1-1:2010
Semiconductor converters – General requirements and line commutated
converters – Part 1-1: Specification of basic requirements
IEC 60204-1:2005
+A1:2008
EN 60204-1:2006
+AC:2010
Safety of machinery. Electrical equipment of machines. Part 1: General
requirements.
Provisions for compliance: The final assembler of the machine is responsible for
installing emergency-stop device.
IEC 60529:1989
EN 60529:1991
Degrees of protection provided by enclosures (IP code)
IEC/EN 60664-1:2007 Insulation coordination for equipment within low-voltage systems. Part 1:
Principles, requirements and tests
IEC/EN 61439-1:2011 Low-voltage switchgear and control gear assemblies -- Part 1: General rules
To Next Page
Loading...
