ABB ACS880 N5700 Series - Page 302

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
43.5 FB A reference 1 (page 140).FB A ref1
53.6 FB A reference 2 (page 140).FB A ref2
83.9 EFB reference 1 (page 140).EFB ref1
93.10 EFB reference 2 (page 140).EFB ref2
103.11 DDCS controller ref 1 (page 140).DDCS ctrl ref1
113.12 DDCS controller ref 2 (page 140).DDCS ctrl ref2
123.13 M/F or D2D ref1 (page 141).M/F reference 1
133.14 M/F or D2D ref2 (page 141).M/F reference 2
15ReservedMotor
potentiometer
16Not in use.PID
18Control panel reference, with initial value from last-used
panel reference. See section Using the control panel as
an external control source (page 25).
Control panel (ref
saved)
19Control panel reference, with initial value from previous
source or actual value. See section Using the control
panel as an external control source (page 25).
Control panel (ref
copied)
See Terms and abbreviations (page 130).Other [value]
Not selected / uint32Parameters 26.51…26.58 configure the oscillation
damping function. See section Oscillation
damping (page 82), and the block diagram on page 655.
This parameter enables (or selects a source that
enables) the oscillation damping algorithm.
1 = Oscillation damping algorithm enabled
Oscillation damping26.51
00Not selected
11Selected
2Digital input DI1 (10.2 DI delayed status, bit 0).DI1
3Digital input DI2 (10.2 DI delayed status, bit 1).DI2
4Digital input DI3 (10.2 DI delayed status, bit 2).DI3
5Digital input DI4 (10.2 DI delayed status, bit 3).DI4
6Digital input DI5 (10.2 DI delayed status, bit 4).DI5
7Digital input DI6 (10.2 DI delayed status, bit 5).DI6
10Digital input/output DIO1 (11.2 DIO delayed status, bit
0).
DIO1
11Digital input/output DIO2 (11.2 DIO delayed status, bit
1).
DIO2
See Terms and abbreviations (page 130).Other [bit]
302 Parameters