ABB ACS880 N5700 Series - Page 416

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
- / uint16Activates master/follower communication monitoring
separately for each control location (see section Local
control vs. external control (page 23)).
The parameter is primarily intended for monitoring the
communication with master or follower when it is
connected to the application program and not selected
as a control source by drive parameters.
M/F comm
supervision force
60.32
1 = Communication monitoring active when Ext 1 is
being used.
Ext 1b0
1 = Communication monitoring active when Ext 2 is
being used.
Ext 2b1
1 = Communication monitoring active when local
control is being used.
Localb2
Reservedb3…15
1 = 10000h…FFFFh
Not in use / uint16Enables/disables the use of a fast time level on the
master/follower communication link. If the
master/follower functionality is used for position
control, the parameter must be set to Enable in both
the master and the follower drives.
Fast M/F comm
mode
60.33
0Faster time level disabled.Disabled
1Faster time level enabled.Enable
Not in use / uint16Selects the channel used for connecting an optional
FEA-xx extension adapter.
Extension adapter
com port
60.41
0None (communication disabled).Not in use
1Channel A on FDCO module in slot 1.Slot 1A
2Channel A on FDCO module in slot 2.Slot 2A
3Channel A on FDCO module in slot 3.Slot 3A
4Channel B on FDCO module in slot 1.Slot 1B
5Channel B on FDCO module in slot 2.Slot 2B
6Channel B on FDCO module in slot 3.Slot 3B
13Channel CH 3 on RDCO module (with BCU control unit
only).
ABB engineered drive
/ uint16
In ModuleBus communication, defines whether the
drive is of the “engineered” or “standard” type.
Note: This parameter cannot be changed while the
drive is running.
DDCS controller
drive type
60.50
0The drive is an “engineered drive” (data sets 10…25 are
used).
ABB engineered
drive
1The drive is a “standard drive” (data sets 1…4 are used).ABB standard drive
Not in use / uint16Selects the DDCS channel used for connecting an
external controller (such as an AC 800M).
DDCS controller
comm port
60.51
0None (communication disabled).Not in use
416 Parameters