ABB ACS880 - Parameters; Terms and Abbreviations; What this Chapter Contains

Parameters
What this chapter contains
The chapter describes the parameters, including actual signals, of the control
program.
Terms and abbreviations
DefinitionTerm
Type of parameter that is the result of a measurement or calculation by the
drive, or contains status information. Most actual signals are read-only, but
some (especially counter-type actual signals) can be reset.
Actual signal
(In the following table, shown on the same row as the parameter name) The
default value of a parameter when used in the Factory macro. For information
on other macro-specific parameter values, see chapter Application macros.
Def
Note: Certain configurations or optional equipment may require specific de-
fault values.
These are labelled as follows:
(95.20 bx) = Default changed or write-protected by parameter 95.20, bit x.
(In the following table, shown on the same row as the parameter range, or
for each selection)
FbEq
16b / 32b
The scaling between the integer used in communication and the value shown
on the panel when a 16-bit value is selected for transmission to an external
system. The scaling is indicated for both 16-bit and 32-bit values. A dash (-)
indicates that the parameter is not accessible in that format.
8
Parameters 169