Parameter group summary
PageContentsGroup
174
Basic signals for monitoring the drive.
1 Actual values
179
Values of references received from various sources.
3 Input references
181
Information on warnings and faults that occurred last.
4 Warnings and faults
189
Various run-time-type counters and measurements related to
drive maintenance.
5 Diagnostics
191
Drive control and status words.
6 Control and status words
204
Information on drive hardware, firmware and application program.
7 System info
208
ESP signals to monitor the pump.
9 ESP signals
211
Configuration of digital inputs and relay outputs.
10 Standard DI, RO
218
Configuration of digital input/outputs and frequency
inputs/outputs.
11 Standard DIO, FI, FO
224
Configuration of standard analog inputs.
12 Standard AI
230
Configuration of standard analog outputs.
13 Standard AO
236
Configuration of I/O extension module 1.
14 I/O extension module 1
264
Configuration of I/O extension module 2.
15 I/O extension module 2
270
Configuration of I/O extension module 3.
16 I/O extension module 3
276
Selection of local and external control location sources and
operating modes.
19 Operation mode
279
Start/stop/direction and run/start/jog enable signal source
selection; positive/negative reference enable signal source
selection.
20 Start/stop/direction
290
Start and stop modes; emergency stop mode and signal source
selection; DC magnetization settings; autophasing mode
selection.
21 Start/stop mode
301
Speed reference selection; motor potentiometer settings.
22 Speed reference selection
311
Speed reference ramp settings (programming of the acceleration
and deceleration rates for the drive).
23 Speed reference ramp
318
Speed error calculation; speed error window control configuration;
speed error step.
24 Speed reference
conditioning
326
Speed controller settings.
25 Speed control
338
Settings for the frequency reference chain.
26 Torque reference chain
347
Settings for the frequency reference chain.
28 Frequency reference chain
357
Drive operation limits.
30 Limits
366
Configuration of external events; selection of behavior of the
drive upon fault situations.
31 Fault functions
380
Configuration of signal supervision functions 1…3.
32 Supervision
389
Configuration of maintenance timers/counters.
33 Generic timer & counter
397
Motor thermal protection settings such as temperature
measurement configuration, load curve definition and motor fan
control configuration.
35 Motor thermal protection
412
Peak value and amplitude logger settings.
36 Load analyzer
Parameters 171
To Next Page
Loading...
