ABB ACS880 - Page 172

PageContentsGroup
417 Settings for user load curve. 37 User load curve
420 Parameter values for process PID control. 40 Process PID set 1
435 A second set of parameter values for process PID control. 41 Process PID set 2
438 Settings for the internal brake chopper. 43 Brake chopper
441 Configuration of mechanical brake control. 44 Mechanical brake control
447 Settings for the energy saving calculators. 45 Energy efficiency
451 Speed supervision settings; actual signal filtering; general scaling
settings.
46 Monitoring/scaling
settings
456 Data storage parameters that can be written to and read from
using other parameters’ source and target settings.
47 Data storage
459 Communication settings for the control panel port on the drive. 49 Panel port communication
463 Fieldbus communication configuration. 50 Fieldbus adapter (FBA)
472 Fieldbus adapter A configuration. 51 FBA A settings
474 Selection of data to be transferred from drive to fieldbus
controller through fieldbus adapter A.
52 FBA A data in
475 Selection of data to be transferred from fieldbus controller to
drive through fieldbus adapter A.
53 FBA A data out
476 Fieldbus adapter B configuration. 54 FBA B settings
478 Selection of data to be transferred from drive to fieldbus
controller through fieldbus adapter B.
55 FBA B data in
479 Selection of data to be transferred from fieldbus controller to
drive through fieldbus adapter B.
56 FBA B data out
480 Configuration of the embedded fieldbus (EFB) interface. 58 Embedded fieldbus
489 DDCS communication configuration. 60 DDCS communication
505 Defines the data sent to the DDCS link. 61 D2D and DDCS transmit
data
510 Mapping of data received through the DDCS link. 62 D2D and DDCS receive
data
519 Enables ESP function parameters. 74 ESP control
525 Controls frequency/speed reference settings of a drive. 75 ESP reference setup
532 Enables ESP automatic control.
See section ESP production mode.
76 ESP automatic control
537 Enables/Disables Underload and Overload protection functions. 79 Load protection
546 Monitors voltage in the motor. 80 Voltage control
552 Enables pump cleaning function. 81 Pump cleaning
559 Estimates flowrate of pump curves in ESP application. 85 Q-H pump curves
565 Motor and load feedback configuration. 90 Feedback selection
576 Configuration of encoder interface modules. 91 Encoder module settings
580 Settings for encoder 1. 92 Encoder 1 configuration
587 Settings for encoder 2. 93 Encoder 2 configuration
589 Control of the supply unit of the drive, such as DC voltage and
reactive power reference.
94 LSU control
172 Parameters