ABB ACS880 - Page 237

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
- / uint16(Visible when 14.1 Module 1 type = FIO-11)
Displays the status of the digital input/outputs on the
extension module. The activation/deactivation delays
(if any are specified) are ignored. A filtering time (for
input mode) can be defined by parameter 14.8 DIO filter
time.
Bit 0 indicates the status of DIO1.
Note: The number of active bits in this parameter
depends on the number of digital input/outputs on
the extension module.
Example: 1001b = DIO1 and DIO4 are on, remainder are
off.
This parameter is read-only.
DIO status14.5
- / uint16(Visible when 14.1 Module 1 type = FIO-01)
Displays the status of the digital input/outputs on the
extension module. The activation/deactivation delays
(if any are specified) are ignored. A filtering time (for
input mode) can be defined by parameter 14.8 DIO filter
time.
Bit 0 indicates the status of DIO1.
Note: The number of active bits in this parameter
depends on the number of digital input/outputs on
the extension module.
Example: 1001b = DIO1 and DIO4 are on, remainder are
off.
This parameter is read-only.
DIO status14.5
- / uint16(Visible when 14.1 Module 1 type = FDIO-01)
Displays the delayed status of the digital inputs on the
extension module. The word is updated only after
activation/deactivation delays (if any are specified).
Bit 0 indicates the status of DI1.
Note: The number of active bits in this parameter
depends on the number of digital inputs on the
extension module.
Example: 0101b = DI1 and DI3 are on, remainder are off.
This parameter is read-only.
DI delayed status14.6
- / uint16(Visible when 14.1 Module 1 type = FIO-11)
Displays the delayed status of the digital input/outputs
on the extension module. This word is updated only
after activation/deactivation delays (if any are
specified).
Bit 0 indicates the status of DIO1.
Note: The number of active bits in this parameter
depends on the number of digital input/outputs on
the extension module.
Example: 1001b = DIO1 and DIO4 are on, remainder are
off.
This parameter is read-only.
DIO delayed status14.6
Parameters 237